Fagor CFI-4GLSTANAT Betriebsanweisung PDF herunterladen (Seite 13)

1/ INSTALLING YOUR APPLIANCE

13

EN

•

Adjust the hob connections: these are

located underneath the control knobs

(Fig. 04)

.

—

Proceed one tap at a time.

—

Remove the control knobs and the gaskets

by pulling upwards.

- Switching from natural gas to

butane/propane

-

Using a small flat-head screwdriver, fully

tighten the brass burner power screws

(yellow)

(Fig. 05),

in a clockwise direction.

-

Replace the gaskets and the control knobs,

noting their direction and ensuring that the

control knobs are fully inserted.

- Switching from butane/propane to natural

gas

-

Unscrew the brass (yellow) burner power

screws

(Fig. 05)

, using a small flat-head

screwdriver, turn twice anti-clockwise.

-

Replace the control knob.

-

Ignite the burner in maximum heat mode,

then turn down to reduced heat mode.

-

Remove the control knob again, then turn

the burner power screw clockwise until it

reaches the lowest possible setting without

extinguishing the flame.

-

Replace the gasket and control knob.

-

Repeatedly change from the maximum to

the minimum flow rate: the flame must not go

out ; if it does, unscrew the burner adjustment

screw to achieve good flame retention during

these changes.

-

Replace the burner heads, burner covers

and pan supports on the hob.

Sealing ring

Tap

Fig. 04

Fig. 05

Tap axis

Burner power

adjustment screw

Control Knob

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare